We offer the best quality and price for the incinerators that can be used in the hospital and industrial
Configuration and technical introduction of medical furnace. This series is the newly developed on the basis of the same products from home and abroad, with an efficient capability to process solid contaminated materials such as surgery castoffs, virus carrying materials, waste paper and etc for hospitals in various levels, as well as to process contamination and garbage for slaughterhouses, breeding houses, blood centers, epidemic prevention units and etc.
Capacity sizes:
We have 4 different capacity sizes for incinerators as follows:
- 20 kg/hr
- 50 kg/hr
- 100 kg/hr
- 150 kg/hr
Temperature inside: 800-10000C
Burning efficiency: >98%
Power consumption: 1.3KW
Noise: <78dB
Index of let smoke and waste gas: Ringelman's smoke index< level 1
Smoke concentration Gas:25.5(mg/m3)
SO Gas: 0.065
NOX Gas: 0.038
H2S Gas: 0.008
CO Gas:35.64
Requirements: Incombustible and explosive materials not allowed in.
Process manner: Two combustion cabinets (wetness drying, high temperature dust removal)
Combustion utensil: From Italy
Specification:
1. Capacity listed above is the processed amount of the combustible solid and waste at a heat value of 1000-3000 kilocalorie /Kg per hour.
2. The chimney is not included in the height of the equipment.
Regulations of the standards authenticated.
Temperature in the initial combustion cabinet: >7000C
Temperature in the reprocessing cabinet: >9000C
Decrement of medical garbage: >95%.
Temperature over the surface of the furnace: 800C; noise: =80dB(A)
Smoke let from burnt medical garbage: =200mg/m3
Lingelman's index: = level 1
Smoke and gas output
Maximum toxic articles let from burnt medical garbage are in accord with the values in the list beneath
Names of the toxic articles
Max amount Kg/h
Sulfur dioxide:11.0
Nitrogen oxides:6.0
Carbon monoxide:120.0
Hydrogen chloride:0.4
Ignition :by electrode can be successful within 0-30 seconds, if a failure, there is an alarm in time.
Electrical security: Electrical components on the furnace can stand a test of the impact from AC 1500V, 50HZ sine wave for 1 minute, without sparkle and destruction.
Power leakage to the ground is less than 5mA normally, and less than 10mA under single failure
Click to enlarge image
Related Keywords:
Bookmark / Share this page